PRI-600 PREROLL INFUSION SYSTEM
CREDENCE
PRI-600 PRE-ROLL INFUSION SYSTEM
Abstract:
Credence PRI-600 is the most advanced
Preroll Infusion System on the Cannabis Manufacturing Market.
It will reliably infuse up to 300-400 prerolls per hour OR 2400-3200 per day –
while accurately placing infused material
exactly where you specify within the preroll.
This machine has several novel features
which aid in the quick setup of the system
and provide consistency in the infusion process.
Introduction
Credence PRI-600 is based upon Credence proven technology
and is an extension of the CFS-1000 platform.
Credence PRI-600 has a PLC controller and Display screen with input buttons.
The Elevator (or Z mechanism) is a servo-motorized,
vertically moving platform that has specific tooling attached to it
to raise the preroll support tube with the preroll inside, vertically upward,
impaling the preroll onto the heated dispensing needle.
The Z moves quickly up when the preroll tube is loaded
and the metal band on the preroll tube is sensed by the controller.
The Z moves up, full speed, until the Upper Switch is made.
The Z then begins to lower at a controller-calculated speed
while the pump dispenses the material
at a set rate to match your desired inputs.
The Z continues downward until the pump finishes the dispensing
and then switches into full speed to the bottom.
The preroll tube with the infused preroll is removed
and the next preroll tube with preroll is inserted.
While the next preroll is being infused,
the operator ejects the finished infused preroll from its tube
and loads the next preroll into the tube ready for infusion.
There is ample time during the infusion process to unload
and reload the preroll from the support tube,
if the workplace is laid out properly.
Then a *normal flow process* occurs which will yield consistent product
at a rate of up to 600 per hour
converting prerolls to Hash Holes [infused].
This process begins with your oil.
Each oil (distillate, live resin, etc.) has an optimum temperature,
and pump speed (rpm) that allows the oil to flow readily
in the infusion process.
Too high of viscosity (too thick) will hamper the infusion process
by causing back-pressure which causes variation in the dispense amount
and the way the dispensing occurs within the preroll.
Too fast of a pump speed can cause cavitation
or loss of steps which result in variation as well.
The temperature and pump speed work together to give you
the optimum oil flow for infusing.
Too cold of oil can be compensated for by slowing the pump speed
and/or reducing the output amount per stroke.
It is imperative that you set the temperatures high enough
to get the oil to flow easily and consistently.
The motor-current of the *Vessel Stirrer* is monitored by the software
and is used to make sure the oil viscosity is low enough
to flow through the pump adequately.
This is a settable variable that should be set
for your specific oil characteristics.
Credence PRI-600 can also fill up to 2000 Vapes
and up to ~720 Syringes – per hour
OR – ~16,000 Vapes and 5,600 Syringes PER DAY!
providing your area is set up for this assembly flow.
